Cooper&Hunter CH09VCT230V Handbuch und Anleitung

HIGH-WALL DUCTLESSAIR CONDITIONING &HEATING SYSTEMOWNER'S MANUALModels:CH09VCT115VI/CH09VCT115VOCH12VCT115VI/CH12VCT115VOCH09VCT230VI/CH09VCT

6(Display content or position may be different from above graphics, please refer to actual products)Parts NameIndoor Unitair inletpanelaux.buttonhoriz

Parts NameDisplay content or position may be different from above graphics, please refer to actual products.DisplayW R Gtemp.indicatordisplayreceiverw

8Introduction for icons on display screenSend signalTurbo mode46°F(8°C) heating functionSet temperatureSet timeTIMER ON/TIMER OFFChild lockUp&down

9● When selecting auto mode, air conditioner will operate automatically according to ex-factory setting. Set temperature can’t be adjusted and will

10Introduction for buttons on remote controllerFAN buttonSWING button34Pressing this button can set fan speed circularly as: auto (AUTO), low( ), m

11SLEEP buttonTEMP button78Introduction for buttons on remote controller▲▲Under COOL, HEAT or DRY mode, press this button to start up sleep function.&

12● It’s defaulted to display set temperature when turning on the unit. There is no display in the remote controller.● Only for the models whose in

13Function introduction for combination buttonsEnergy-saving functionUnder cooling mode, press "TEMP" and " CLOCK" buttons simulta

14Child lock functionPress "▲" and " " simultaneously to turn on or turn off child lock function. Whenchild lock function is on

151. After putting through the power, press "ON/OFF" button on remote controller to turn on the air conditioner.2. Press "MODE"

CH09VCT115VI/CH09VCT115VO (115V)System Includes: CH09VCT115VI, CH09VCT115VOCH12VCT115VI/CH12VCT115VO (115V)System Includes: CH12VCT115VI, CH12VCT115VO

16Emergency operationIf remote controller is lost or damaged, please use auxiliary button to turnon or turn off the air conditioner. The operation in

17Clean and maintenance234Open panelPull out the panel to a certain ● Use dust catcher or water to the water (below 113°F(45°C) ) to clean it, and

18Clean and maintenance1. Check whether air inlets and air outlets are blocked.2. Check whether circuit break, plug and socket are in good condition.4

19Malfunction analysisGeneral phenomenon analysisPlease check below items before asking for maintenance. If the malfunction stillcan’t be eliminated,

20Malfunction analysis● Power failure?● Is plug loose?● Circuit break trips off or fuse is burnt out?● Wiring has malfunction?● Unit has restarted

21Phenomenon Check items SolutionOdours are emitted● Whether there’s odour source, such as furniture and cigarette, etc.● Eliminate the odour sou

22Error Code● When air conditioner status is abnormal, temperature indictor on indoor unit will ation of error code.Error codeE5E8U8H6C5F1F2Troubles

COOLING OPERATIONHow it works:In cooling mode, your victoria indoor unit will absorb heat from the room, then the victoria outdoor unit will dischar

ENERGY SAVING TIPS1. Relaxing room temperature at night is OK: During the nighttimehours you don’t require the same level of conscious cooling or heat

LIMITED WARRANTY STATEMENTDuctless Heat Pump Split System FOR WARRANTY SERVICE OR REPAIR: Contact your installing contractor. You may find the instal

Explanation of SymbolsIndicates a hazardous situation that, if not avoided, willresult in death or serious injury. Indicates a hazardous situation th

LIMITATIONS OF WARRANTIES: ALL IMPLIED WARRANTIES AND/OR CONDITIONS (INCLUDING IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A

ContentOperation NoticesPrecautions. ...1Parts

1PrecautionsWARNINGDo not connect air conditioner to multi-purpose socket.This appliance is not intended for use by persons (incl-Operation and Mainte

Do not block air outlet or air inlet. It may cause malfunction.remote controller may be broken.● Power cord is overheating or damaged.● There’s abnorm

Do install the circuit break. If not, it may cause malfunction. of at least 1/8in (3mm) in all poles should be connected in fixed wiring.magnet buckle

Installation must be performed in accordance with the persons in order to avoid a hazard.must be properly grounding with specialized grounding device

The indoor unit should be installed close to the wall. reachable after finishing installation.far away from animals or plants.If it is unavoidable, pl